已发表: 05/21/2020
已发表: 05/21/2020
An operator wanted to drill an 8 1/2-in interval in an interbedded shale and sandstone formation in the Gulf of Thailand that was very soft at its top but increased in unconfined compressive strength (UCS) from 3,000 to 5,000 psi at the bottom of the interval. Undesired bit dulls and cutter damage occurred from impact with hard formation stringers in combination with high rpm and high ROP ranging from 4,000 to 5,000 ft/h [1,219 to 1,524 m/h].
The benchmark bit drilled with high ROP, but the operator wanted a bit that could deliver higher ROP while withstanding impact with the formation.
To increase durability while optimizing ROP through the interbedded shale and sandstone formations, Schlumberger recommended the HyperBlade hyperbolic diamond element bit. It incorporates Hyper hyperbolic diamond cutting elements with a thicker, precision-molded diamond table to increase overall bit durability, enabling the bit to better withstand impact damage caused by formation transitions. The unique geometry of the cutting element breaks rock into smaller pieces that are easier to remove.
Featuring a positive rake that cuts up to 20% deeper into the formation, the Hyper element improves ROP over conventional flat cutters. The Hyper elements also require less vertical load and circumferential force to penetrate and shear rock. Thus, the HyperBlade bit improves drilling efficiency and toolface control in soft formations.
The HyperBlade bit drilled the 8 1/2-in interval with an average 1,282-ft/h ROP, a 17% increase in ROP over the average 1,092-ft/h benchmark bit while using 16% less WOB. The HyperBlade bit also maintained steerability more effectively—with less reactive torque—than the benchmark bit and was better at staying true to build and turn.
The HyperBlade hyperbolic diamond element bit drilled faster than high-ROP benchmark bit with good directional control and little affect from drilling hard stringers interbedded in shale.
