已发表: 10/30/2012
已发表: 10/30/2012
| Well Information |
|
| Location | Buzzard Field, 19/10 - 1z, North Sea |
| Mud System | GLYDRIL (KCl/ Glycol WBM) |
| Completion Date | January 2002 |
| Section Hole Size | 8 1/2-in Sidetrack |
| Section Length | 6987 ft tangent |
| Hole Angle | 43º maximum |
The 8 1/2-in directional assembly, drilling in the Buzzard Field, encountered low rates of penetration upon entry into the Rodby Claystone Formation. Rates dropped to below 10ft/hr, despite efforts to alter the drilling parameters. The assembly was pulled on two occasions where the bit found to be balled with compacted claystone.
Different Pills of KCL brine, Nutplug, GLYDRILL and caustic proved ineffective in improving penetration rates. Following a further trip to replace a failed mud motor and a continued rate of penetration of only 15ft/hr, it was decided to introduce silicate to the circulating GLYDRIL system.
Additional inhibition of the system may slow down the accretion process by slowing down the rate at which the shales hydrate hence remain in a plastic state longer. M-I provided an addition of 2% by volume of SILDRIL into the GLYDRIL System.
A pilot test with 5% by volume of sodium silicate liquor showed an unacceptable increase in the system rheology.
SILDRIL (M-I's Sodium Silicate Liquor) is the primary constituent of MI's highly effective water based SILDRIL system, but has proved effective as a simple addition to MI's GLYDRIL system to cure bit-balling.
Sodium Silicate Liquor can be used in a range of concentrations and has a HOCNS category E, so is therefore environmentally friendly, and facilitates full discharge to the sea.
“ Recent drilling in the Buzzard Field, operated by EnCana (U.K.) Limited, has provided several cases of extended periods of low rate of penetration attributed to bit-balling. During a suspected case of bit-balling whilst drilling Well 19/10 -1z, MI’s GLYDRIL† water based system was treated with sodium silicate liquor, resulting in an immediate increase in rate of penetration.”
Simon Gibb, Senior Account Manager
If you’d like to know more about GLYDRIL or SILDRIL, please call the M-I SWACO office nearest you.
Challenge: The 8 1/2-in directional assembly, drilling in the Buzzard Field, encountered low rates of penetration.
Solution: M-I SWACO provided an addition of 2% by volume of SILDRIL system into the GLYDRIL system.
Results: Penetration increased from 15 ft/h to 40 ft/h.
