Hydrocarbons are trapped at great depths with pressure and temperature higher than surface conditions which would vary depending on reservoir properties. When the well is set on production, these hydrocarbons travel through the wellbore over reducing geothermal and formation pressure gradients. Hence, at shallower depths the temperature drops below the cloud point and sometimes, below pour point of crude thus creating an ambient temperature for the formation of wax and deposition of paraffin on the inner side of production tubing.

It has been observed that when hot fluid passes through a pipe which is covered by a continuously circulating hot water bath, the temperature difference of the fluid at surface outlet and sub-surface reservoir is reduced to a minimal value. This paper therefore proposes a practical application of such heat transfer within a wellbore for passively solving major industrial issues of paraffin depositions. The idea lies in minimizing the heat losses, which can be effectively done by insulating the inner side of the casing so that the annulus and fluid flowing within the tubing is isolated from exterior losses. According to the First law of Thermodynamics the fluid flowing within the tubing will experience reduction in thermal gradient. These loses can be compensated by injecting hotter brine through a pipe at the bottom of the annulus, which is isolated, using production packer. Further, circulating hot fluid in the annulus would result in isothermal heating of the fluid flowing through the tube which would minimize the heat loss across tubing, causing an increase in temperature of fluid at the surface above pour point. Several researchers have put forth heat transfer equations across the tubing's, annulus, insulator, casing, cement and the formation which can be used to calculate the overall heat transfer coefficient and thus, the amount of heat losses. Quartz sensors placed at the bottom of a wellbore would detect bottom borehole temperature based on which the injection temperature of fluid can be manipulated. The entire process can be automated by applying an artificial intelligent system which would monitor, control and respond. This method would increase the capex but would decrease the operating cost thus leading to an increase in the life of the well.